EN – Translation of the original user manual - 2.0 | 2019
2.4 SAFETY PROVISIONS EMPLOYED
To protect people and goods from injury or damage, the gate is fitted with
safety provisions including safety edges and/or photocells.
These serve as emergency provisions that immediately stop and reverse the
movement of the gate. It is forbidden to use these provisions to stop the
gate normally.
For a gate with hold-to-run control, the above-mentioned safety provisions
are not necessary and will therefore not be standard provisions.
With this type of operation, the gate stops immediately as soon as the
switch is released.
2.5 INTENDED USE
The gate is intended to control access to a specific plot, premises or site. The gate
is intended for both industrial and private use.
The gate drive and control unit is adjusted to the options agreed with the
user. The relevant options are laid down during hand-over.
Carefully read this user manual before operating the gate. You must always be
familiar with the operating mode the gate is in.
2.6 SAFETY DURING USE
Children or people with a disability must not operate the gate. Parents must
supervise their children to prevent them playing with the gate.
PARENTS ARE RESPONSIBLE FOR THEIR CHILDREN
Keep a safe distance from the moving gate. Warning icons to this effect
have been installed in various locations.
Only pass through the gate when it is completely open.
The gate must not be operated in windy conditions, wind force ≥9
Beaufort. The gate leaf can swing in a way that can result in damage to
the construction.
The safety edges serve as emergency facilities to immediately stop and
reverse the gate movement. Using them as a regular gate stop feature is
not allowed. Since the head stiles of the gate have safety edges that
cannot cover their full height, there is still some risk of people getting
trapped by the gate here.
To Next Page
Loading...