EN – Translation of the original user manual - 2.0 | 2019
shows the encrypted numeric value of the radio signal received and the memory
location where this transmitter was stored:
The display then jumps back to the menu. By activating this menu item once
again, additional transmitters may be registered one after another.
If the program does not recognize any valid code within 20 seconds of the
registration process being activated, the display jumps back to the menu.
Deleting a transmitter 7.11.4
If a certain handheld radio transmitter or a specific transmitter key is to be
deleted from the control system memory, this can be realized via the menu item
“Delete transmitter”.
Menu: “RadioRemoteControl”, activate “Delete transmitter”
The top line of the display shows “Delete transmitter”. The operator now has 20
seconds to press the required key on the handheld transmitter to delete the
transmitter from the control system memory. After deletion the display jumps
back to the menu.
If the program does not recognize any valid and stored code within 20 seconds
after the deletion process being activated, the display jumps back to the menu.
Deleting a transmission location 7.11.5
If a certain handheld radio transmitter or a specific transmitter key is to be
deleted from the control system memory and the corresponding handheld
transmitter is not available, this can be realized via the menu item “Delete
transmitter location”.
Menu: “RadioRemoteControl”, activate “Delete transmitter location”
A list of all programmed handheld transmitters and functions is shown. The
memory location to be deleted is selected by turning the selection switch. After
the rotary button has been pressed, the display shows the query “Delete entry?”.
Pressing the rotary button again will delete this entry and this is then confirmed
by the display indication “Done”.
RF#: xxxxxxxxxxxx
Pos.: p
To Next Page
Loading...
