EN – Translation of the original user manual - 2.0 | 2019
in non-EC countries.
The Delta gate has highly tensioned cables fitted in the bottom rail.
If these cables are damaged, they can snap with great force. This
can lead to serious injury. Therefore, it is prohibited to drill into or
grind these rails.
!! Only people trained by Heras are allowed to disassemble the
bottom rail.
If the gate is damaged, always contact the supplier for an inspection.
Illustration 2: Warning sticker bottom rail
OPERATION 3
3.1 OPENING/CLOSING SLIDING GATE - NORMAL USE
The gate can be operated using pulse operation, for instance via a button or key
switch. The location of the operating device depends on the customer's choice or
the operating mode.
OPEN:
Press the “Open” button. The gate slides open to the next end position.
This can be completely or partially open (if the
“Partially open” function has been programmed).
CLOSE:
Press the "Close" button. The gate closes completely.
STOP:
Press the "Stop" button. The gate will stop immediately, irrespective of its
direction of travel. To restart the gate press
“Open” or "Close".
To Next Page
Loading...
