Heras HMD Basic - Deleting All Transmitters; Diagnostic Support; Version Display

EN – Translation of the original user manual - 2.0 | 2019
62
Pressing the rotary button once again causes the menu to jump back to the
selection “Delete transmitter location”.
Deleting all transmitters 7.11.6
The menu function “Delete all” removes all handheld radio transmitters from the
control system memory. Neither the transmitters in question, nor a radio
receiver, are required for this. After this menu item has been called up, the
remote control of the gate by handheld radio transmitters is no longer possible
until the next registering process. The following menu item can be used to delete
all transmitters.
 Menu: “RadioRemoteControl”, activate “Delete all”
7.12 DIAGNOSTIC SUPPORT
The HMD24 has a diagnosis menu which can be used to put the control system
into operation and rectify any errors that have occurred.
Version display 7.12.1
The version of the control system can be displayed as follows:
 Menu: “Identification”, “Full version”: The combination of letters and
numbers displayed here uniquely identifies the software used.
 Menu: “Identification”, “Gate version”: The text displayed shows the
designation of the gate for which the control system, software and the
stored parameters are defined.
 Menu: “Identification”, “Serial number”: The serial number of the control
system is displayed.
Following entry of the correct password, the following version parameters are also
visible:
 Version of the motor controller firmware.
 Version of the periphery controller firmware.
 Version of the parameter table data loaded.
 Version of the bootloader software of the motor controller.
 Version of the bootloader software of the periphery controller.