Heras HMD Basic - Page 29

EN – Translation of the original user manual - 2.0 | 2019
29
 Parameter set Version of the installed parameter table
 Bootloader motor Version of the bootloader program of the motor
controller
 Bootloader peri. Version of the bootloader program of the
periphery controller
2. Service access
 Password input Access (password) for the service engineer and
activation of additional performance features
 National language Selection of a different display language in the LC
display
 Motor dir. of rotation Change of the motor direction of rotation left/right
 Time pre-limit switch Setting of the time for the braking curve before
the limit positions are reached
3. Diagnosis
 Gate status Status of control system /gate, inputs and outputs
and of maintenance information
 Sensor status Setting and status of connectable sensors
 System log book Table of the most recent events and faults
including their time stamp (operating time)
 Temperature Display of the temperatures of the power
electronics
 Motor current Display of the maximum motor currents that have
occurred
4. Settings
 Set timer Menu for setting various different timers (closing
movement times etc.)
 Input: In3/4 Selection of functions at the two inputs In3 and
In4
 Safety Selection of the installed safety sensors on the
gate
 Special parameters Settings for maintenance requirements
 Operating mode Selection of hold-to-run operation or automatic
mode
 Parameter backup Menu for parameter backup settings
 Status notification Settings for gate status notifications as relay
output
5. Radio remote control
 Active transmitters Display of the number of registered radio
transmitters
 Register transmitter Register new handheld transmitters with the
functions predefined in the program
 Register trans. OPEN Register new handheld transmitter (key) for the
OPEN function
 Register trans.CLOSE Register new handheld transmitter (key) for the
CLOSE function