DS-7600 Series NVR User’s Manual
32
Start/Stop Auto-Switch: Click to start/ stop auto-switch. Auto-switch will cycle through selected
cameras. Switching of camera can be based on an individual or multiple cameras.
Start Recording: Click the Continues Record/Event Record item. This will bring up an attention box
shown below. If you click yes, it will start all-day continues/event recording of all channels.
Output Mode: Click the Output Mode item. This will bring up an Output Mode menu shown below.
Four modes are available: Standard, Bright, Gentle and Vivid. Select one and click the Apply button to
save the setting.
Note:
Before you start Auto-switch, you should set Dwell Time in Live View setting menu by going to Menu >
System Configuration > Live View > General.
Note:
After 20 seconds of inactivity, the NVR will automatically exit out of the Display menu and go back into
the Live Feed mode.
Note:
The auto lock menu setting is selected by default, meaning the Admin password must be enter to exit out
of the Live Feed into the Main Menu.
To Next Page
Loading...
