DS-7600 Series NVR User’s Manual
61
2. Enter the old password in the Old Password textbox.
3. Check the Change Password checkbox.
4. Enter the new password in the Password textbox.
5. You can also enter the User’s MAC Address of the remote PC. If it is configured and enabled, it
only allows the remote user with this MAC address to access the device.
6. Click the OK button to save the setting and back to the up level.
Adding a New Remote/Local User
You may add up to 31 new users to your NVR.
To add new users:
1. On the User interface shown in Figure 53, click Add to enter Add User interface, as shown in
Figure 54.
Figure 54 Add User Menu
2. Enter the information for new user, including User Name, Password, Level and User’s MAC
Address.
Level: Set the user level to Guest or Operator. Different user levels have different default
operating permission.
Guest: Guest has the default permission of local log search and remote log search.
Operator: Operator has the default permission of local log search, remote log search, two-
way audio and camera configuration.
3. Click the OK button to confirm adding the user. Once a new user has been created, the fields
behind Users will become editable, as shown in Figure 55.
Figure 55 User Settings Menu
To Next Page
Loading...
Need help?
General
