To Next Page

To Previous Page

DS-7600 Series NVR User’s Manual

 Manual: Edit the port by click .

4. Click the Apply button to save the settings.

Configuring More Settings

You can configure alarm host and port by selecting the more setting tab, as shown in Figure 51.

Figure 51 More Settings Menu

1. Alarm Host: Send the alarm event or exception message to the alarm host when an alarm is

triggered. The remote alarm host must have the CMS (Client Management System) Software

installed.

 Enter the IP address of the remote PC on which the CMS Software is installed in.

 Enter the alarm monitoring port in Alarm Host Port, which must be the same as the port

configured in the software.

2. Port:

 Server Port: Enter the Server Port which designates the port to be used with the client

software.

 HTTP Port: Enter the HTTP Port which refers to the one to be used with the built-in Web

Server.

 Multicast IP: Enter the Multicast IP to enable multicast.

 RTSP Port: Enter the PTSP Port. PTSP is a network control protocol designed for use in

entertainment and communication systems to control streaming media servers.

 HTTPS Port: Check the Enable HTTPS checkbox and enter the HTTPS Port. HTTPS is used

for secure communication over network.

3. Enable High-speed Download: You can enable the High-speed Download function to widen the

outgoing bandwidth of the device. In this way you can speed up the download of record files

through IE browser or CMS software.

4. Click Apply to save the network settings and click to return to the previous menu. Click

without clicking Apply will quit out of the menu without saving settings.

Note:

If you enable the high-speed download function, the local menu operation will be affected. It is

recommended to disable this function after finishing the remote downloading of record files.

HIKVISION DS-7600NI-SE/P Series User Manual

Questions and Answers: