HIKVISION DS-K1T321 Series

Chapter 3 Installaon
3.1 Installaon Environment
●
Indoor use only.
●
Avoid backlight, direct sunlight, and indirect sunlight.
●
For
beer recognion, there should be light source in or near the installaon environment.
●
The minimum bearing weight of the wall or other places should be 3
mes heavier than the
device weight.
3.2 Install with Gang Box
Steps
1.
Make sure the gang box is installed on the wall.
Note
You should purchase the gang box separately.
Figure 3-1 Install Gang Box
2.
Secure the mounng plate on the gang box with two supplied screws (SC-KA4X22).
DS-K1T321 Series Face Recognion Terminal
4