HIKVISION DS-K1T321 Series User Manual

3.
Enable the Wi-Fi funcon.
4.
Select a Wi-Fi from the list, and enter the Wi-Fi's password. Tap OK.
Note
Only digits, leers, and special characters are allowed in the password.
5.
Set the Wi-Fi's parameters.
-
By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the
gateway
automacally.
-
If disable DHCP, you should enter the IP address, the subnet mask, and the gateway manually.
6.
Press OK to save the
sengs and go back to the Wi-Fi tab.
7.
Press ESC to save the network parameters.
7.2.3 Set ISUP Parameters
Set ISUP parameters and the device can upload data via ISUP protocol.
Before You Start
Make sure your device has connect to a network.
Steps
1.
Select Comm. → ISUP .
DS-K1T321 Series Face Recognion Terminal
28

HIKVISION DS-K1T321 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T321 Series
Category	Touch terminals
Language	English