7.1.2 Login by Acvaon Password
You should login the system before other device operaons. If you do not congure an
administrator, you should follow the
instrucons below to login.
Steps
1.
Long press OK to enter Authencate via Admin page.
2.
Press to enter the password.
-
If you have added an administrator for the device, press OK and enter the password.
-
If you haven't added an administrator for the device, enter the password.
3.
Press OK to enter the home page.
Note
The device will be locked for 30 minutes aer 5 failed password aempts.
7.1.3 Forgot Password
If you forget the password during authencaon, you can change the password.
Steps
1.
Long press OK to enter Authencate via Administrator page.
2.
Press to enter the password entering page, and then press ESC.
3.
Select Forgot Password.
4.
Answer the security
quesons that congured when acvaon.
5.
Create a new password and conrm it.
6.
Press OK.
7.2
Communicaon Sengs
You can set the wired network, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
parameters, ISUP and access to Hik-Connect on the communicaon sengs page.
7.2.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, the
gateway, and DNS parameters.
Steps
1.
Select Basic → Comm.
(Communicaon) to enter the Communicaon sengs page.
2.
On the Communicaon page, select Wired Network.
DS-K1T321 Series Face Recognion Terminal
25