DS-KV8x13-WME1 Video Intercom Villa Door Station User Manual
UM DS-KV8x13-WME1 Villa Door Station 062321NA 23
5.5.
System Settings
Follow the instructions below to configure the system settings, include System Settings, Maintenance,
Security, User Management, etc.
Click System to enter the settings page.
• Basic Information: Click System Settings → Basic Information to enter the settings page. On the page,
you can edit Device Name and Device No. Set the Language and System Type according to your needs.
Click Save to enable the settings.
• Time Settings: Click System Settings → Time Settings to enter the settings page. Select the Time Zone of
your location from the drop-down list.
Enable NTP, set the Server Address, NTP Port, and Interval.
Enable Manual Time Sync., set the time manually or check the Sync. with computer time.
Click Save to enable the settings.
• DST: Click System Settings → DST to check Enable DST. Set the parameters according to your needs and
click Save to enable the settings.
• About: Click System Settings → About and click Open Source Software Licenses to view the details.
• Maintenance: Click Maintenance → Upgrade & Maintenance to enter the settings page.
Figure 18, Maintenance
• Reboot: Click Reboot to reboot the device.
• Restore: Click Restore to reset all the parameters, except the IP parameters and user information, to
the default settings.
• Default: Click Default to restore all parameters to the default settings.
• Export parameters:
Select Device Parameters, and click Export to pop up the dialog box.