HIKVISION HWP-N2404IH-DE3 - Set Pattern Scan; Set Limit

Network Speed Dome User Manual
12
3.4 Set Pattern Scan
The device can move as the recorded pattern.
Steps
Note
This function is only supported by certain models.
1. Click to show the PTZ control panel, and click .
2. Select one pattern scan path that needs to be set.
3. Click to start recording pattern scan.
4. Click PTZ control buttons as demands.
Note
Recording stops when the space for pattern scan is 0%.
5. Click to complete one pattern scan path settings.
6. Click to call pattern scan.
Stop pattern scan.
Reset pattern scan path.
Delete the selected pattern scan.
Note
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config, and check
Clear All Patterns, and click Save.
3.5 Set Limit
The device can only move within the limited range.
Steps
1. Go to Configuration → PTZ → Limit.
2. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans automatically.