Network Speed Dome User Manual
68
9.3.3 Set Port Mapping on Router
The following settings are for a certain router. The settings vary depending on different models of
routers.
Steps
1. Select the WAN Connection Type.
2. Set the IP Address, Subnet Mask and other network parameters of the router.
3. Go to Forwarding ā Virtual Severs, and input the Port Number and IP Address.
4. Click Save.
Example
When the cameras are connected to the same router, you can configure the ports of a camera as
80, 8000, and 554 with IP address 192.168.1.23, and the ports of another camera as 81, 8001, 555,
8201 with IP 192.168.1.24.
Figure 9-1 Port Mapping on Router
Note
The port of the network camera cannot conflict with other ports. For example, some web
management port of the router is 80. Change the camera port if it is the same as the management
port.
To Next Page
Loading...
