Network Speed Dome User Manual
73
Note
● The required verification code is the code you create or change when you enable Hik-Connect
service on the camera.
● If you forget the verification code, you can check the current verification code on Platform
Access configuration page via web browser.
6. Tap Connect to a Network button in the popup interface.
7. Choose Wired Connection.
8. Connect the camera to the router with a network cable and tap Connected in the result
interface.
Note
The router should be the same one which your mobile phone has connected to.
9. Tap Add in the next interface to finish adding.
For detailed information, refer to the user manual of the Hik-Connect app.
9.8 Wi-Fi
Connect the device to wireless network by setting Wi-Fi parameters.
Note
This function is only supported by certain device models.
9.8.1 Connect Device to Wi-Fi
Before You Start
Refer to the user manual of wireless router or AP to set SSID, key, and other parameters.
Steps
1. Go to TCP/IP settings page: Configuration → Network → Basic Configuration → TCP/IP.
2. Select Wlan to set the parameters. Refer to TCP/IP for detailed configuration.
Note
For stable use of Wi-Fi, it is not recommended to use DHCP.
3. Go to Wi-Fi settings page: Configuration → Network → Advanced Configuration → Wi-Fi.
4. Set and save the parameters.
1) Click Search.
To Next Page
Loading...
