Network Speed Dome User Manual
21
4.1.10 Light
Click to turn on or turn off the illuminator.
4.1.11 Lens Initialization
The lens automatically adjusts the zoom and focus value to default settings.
You can initialize the lens in two ways:
● Click on PTZ control panel to reset the lens parameters once.
● Select Lens Initialization as ON in Configuration → Image → Display Settings to reset the lens
parameters once.
4.1.12 Track Manually
In live view, manually select a target for the device to track.
Note
The function may not be supported by certain device models.
Steps
1. Click on the toolbar of the live view page.
2. Click a moving object in the live image.
The device tracks the target and keeps it in the center of live view image.
4.1.13 Conduct 3D Positioning
3D positioning is to relocate the selected area to the image center.
Steps
1. Click to enable the function.
2. Select a target area in live image.
– Left click on a point on live image: the point is relocated to the center of the live image. With
no zooming in or out effect.
– Hold and drag the mouse to a lower right position to frame an area on the live: the framed
area is zoomed in and relocated to the center of the live image.
– Hold and drag the mouse to an upper left position to frame an area on the live: the framed
area is zoomed out and relocated to the center of the live image.
3. Click the button again to turn off the function.
To Next Page
Loading...
Need help?
General
