Network Speed Dome User Manual
14
6. Click Save.
Note
If you want to clear all scheduled tasks, go to Configuration → PTZ → Clear Config, check Clear
All Scheduled Tasks, and click Save.
3.8 Set Park Action
You can set the device to perform an action (for example, preset or patrol) or return to a position
after a period of inactivity (park time).
Before You Start
Set the action type first. For example, if you want to select patrol as park action, you should set
the patrol. See Set Patrol Scan for details.
Steps
1. Go to Configuration → PTZ → Park Action.
2. Check Enable Park Action.
3. Set Park Time: the inactive time before the device starts park action.
4. Select Action Type according to your needs.
5. Select an Action Type ID, if you select patrol or preset as action type.
When the action type is patrol, action type ID stands for patrol No. When the action type is
preset, action type ID stands for preset No.
6. Click Save.
3.8.1 Set One-Touch Park
This function is used to start park instantly.
Steps
1. Refer to Set Park Action to set a park action.
2. Choose from the following methods to start one-touch park.
– Click .
– Call Preset No. 32.
3.9 Set Privacy Mask
Privacy mask enables you to cover certain areas on the live image to prevent certain spots in the
surveillance area from being live viewed and recorded.
Steps
1. Go to Configuration → PTZ → Privacy Mask.
To Next Page
Loading...
Need help?
General
