5.1 Recording Measurement Data
104
Procedure
1. Measure insulation resistance or tem-
perature and stop measurement. (Tem-
perature and humidity can be entered by
key operation.)
2. Press the key.
[MEMO No.] lights up and the No. of the
last stored No. will blink.
3. Choose data No. using the key.
Press the key to display a data
number of another group.
Example: . . . A0 b0 C0 . . .
If the and keys are held down
simultaneously, the lowest number
among the available data numbers
appears.
Temperature only or temperature and
humidity may be stored as a manual record.
The tester, however, has to be in the
standard measurement mode (both [
STEP]
and [
TC] off). They cannot be recorded in the
step voltage test mode ([
STEP] on) or in the
temperature correction mode ([
TC] on).
Change voltage setting
3.2.1 Procedure 5. to 8. (page 60)
Exit temperature correction mode
4.3.2 "Exiting Temperature Correction Mode"
(page 92)
Enter temperature/humidity by key operation.
6.3 "Entering Temperature and Humidity Mea-
sured with External Thermometer and Hygrome-
ter" (page 129)
To Next Page
Loading...
