5.1 Recording Measurement Data
1
2
3
4
5
6
7
8
9
10
11
付録
索引
105
4. Press the key.
[MEMO No.] blinks and data is recorded.
If a number with indicator is cho-
sen, existing data will be overwritten with
new data.
• Temperature may be measured either
before or after insulation resistance
measurement.
• If is indicated for a data No., data
is already recorded under the number. (In
manual recording, data can be
overwritten.)
• If is not pressed and the
key is pressed, the LCD returns to the
previous screen without recording data.
• If step voltage test is stopped at any time,
data cannot be recorded.
• If corrected resistance is indicated as
[
E11] in the temperature correction mode,
data cannot be recorded.
About [E11] 8.3 "Error Display" (page 154)
• Do not turn off power while [MEMO No.] is
blinking. Data will be lost.
To Next Page
Loading...
