12.1 Troubleshooting
162
2. Measurement issues
No Issue Items to check Possible causes Solutions See
2-1 Measured val-
ues are unstable.
Effects of noise Susceptibility to
noise
See Appendix 7(1)(2).
p.A13
p.A15
Measurement leads Clip-type leads See Appendix 7(3).
p.A16
Wiring becomes
two-terminal wir-
ing in middle.
See Appendix 7(10).
p.A19
Measurement target Wide or thick See Appendix 7(4).
p.A17
Temperature is
unstable (just
manufactured,
just opened,
being held by
hand, etc.).
See Appendix 7(5).
p.A17
Low heat capac-
ity
See Appendix 7(6).
p.A18
Transformer,
motor, choke
coil, solenoid
See Appendix 7(1)(7)(8).
p.A13
p.A18
p.A18
TC ON The temperature sensor is not
appropriately positioned.
Move the temperature sensor
closer to the measurement tar-
get.
Position the temperature sensor
so that it is not exposed to wind.
If the response to the measure-
ment target’s temperature
change is slower than the tem-
perature sensor’s response,
increase the response time by
covering the temperature sen-
sor with something. The tem-
perature sensor’s response
time is about 10 minutes (refer-
ence value).
p.13
OFF The measurement target’s resis-
tance value is changing due to the
temperature, for example because
the room temperature has not sta-
bilized.
Turn ON temperature correction
(TC).
p.52
To Next Page
Loading...
