11.4 Auto-Exporting Measured Values (at End of Measurement) (Data Output Function)
236
Preparing connected equipment (PC or PLC)
• When outputting data with the COM port
Place the equipment in the receive standby state. If connecting the instrument to a com-
puter, launch the application software and place it in the receive standby state.
• When outputting data with a virtual keyboard
Launch the application and position the cursor where you wish to enter the text.
1
Open the Settings Screen.
2
Open the Communications Interface Setting Screen.
3
Enable or disable auto-exporting (DATA OUT)
4
Return to the Measurement screen.
The Settings screen
appears.
Switch the function menu
to P.2/3.
1
2
Move the cursor to the [IF] tab
with the left and right cursor
keys.
1
2
Enable auto-exporting
Disable auto-exporting
(default)
Selection
Return to the
Measurement screen.
To Next Page
Loading...
