Hioki RM3545-02 - Connecting the Printer to the Instrument; Chapter 12 Printing (Using an RS-232 C Printer)

12.1 Connecting the Printer to the Instrument
237
12
Before connecting a printer, read "Operating Precautions" (p.12) carefully.
Printer
The requirements for a printer to be connected to the instrument are as follows.
Confirm compatibility and make the appropriate settings on the printer before connecting it
to the instrument.
See: "Instrument Settings" (p. 239)
• Interface..................................... RS-232C
• Characters per line .................... At least 48
• Communication speed............... 9600 bps (default)/ 19,200bps/ 38,400bps/ 115,200bps
• Data bits..................................... 8
• Parity.......................................... none
• Stop bits..................................... 1
• Flow control ............................... none
• Control codes............................. Capable of directly printing plain text
• Message terminator (delimiter).. CR+LF
Printing
(Using an RS-232C Printer) Chapter 12
12.1 Connecting the Printer to the Instrument
Printing (p.240)
• Measured values and
comparator judgments
• List of measurement
conditions and set-
tings
• Statistical calculation
results
Connecting
the printer to
the instrument
Make instrument
settings (p.239)
Make printer
settings