Hioki RM3545-02 - Page 97

4.10 Checking for Poor or Improper Contact (Contact Check Function)
89
4
1
Open the Settings Screen.
2
Open the Measurement Setting Screen.
3
Enable the Contact Check function.
4
Return to the Measurement screen.
The Settings screen
appears.
Switch the function menu
to P.2/3.
1
2
Move the cursor to the
[MEAS] tab with the left and
right cursor keys.
Enables the contact check
function (default setting
when low power is set to
off)
Disables the contact
check function (default
setting when low power is
set to on)
Selection
2
1
Return to the
Measurement screen.