Hirschmann GRS103 Series User Manual

Installation GRS103
Release 01 03/2022
11
2.6 Device casing
Only technicians authorized by the manufacturer are permitted to open the
casing.
 Never insert sharp objects (small screwdrivers, wires, etc.) into the inside
of the device.
 Verify that the electrical installation meets locally or nationally applicable
safety regulations.
 Keep the ventilation slits free to ensure good air circulation.
 Make sure there is at least 10 cm (3.94 in) of space in front of the
ventilation slits of the casing.
 Do not touch the casing during operation or shortly after switching off the
device. Hot surfaces can cause injury.
 If you are operating the device in a 19" switch cabinet: install sliding/
mounting rails for supporting the weight of the device.
 Exclusively use Hirschmann mounting brackets.
 Exclusively use the provided screws when you reposition the attached
mounting brackets or install additional mounting brackets. You obtain the
additional brackets as accessories.
See “Accessories” on page 77.
 Mount the device horizontally or vertically, in a 19" switch cabinet
(figure 22 on page 47) or on a flat surface (figure 20 on page 44).
 Only switch on the device when the casing is closed.
2.6.1 ESD Guidelines
Media modules are equipped with electrostatically sensitive components.
These can be destroyed by the effect of an electric field or by charge
equalization when touching the printed circuit board or the contacts, or their
lifetime can be affected. Media modules are therefore delivered packed in a
conductive ESD protection bag. The packaging is reusable.
Make sure you adhere to the following protection measures for
electrostatically endangered assemblies:
 Create electrical equipotential bonding between yourself and your
environment, e.g. using a wristband, which you clamp to the basic device
(knurled screw of an interface card). When the power supply cable is
connected, the basic device is grounded via the power supply connection.
 Only now do you take the card out of the conductive bag.
 Outside the basic device, only store the cards in a conductive ESD
protective bag.
 ESD protective field equipment is available for the safe handling of
electrostatically endangered assemblies.
Further information about electrostatic sensitive modules can be found in
DIN EN 61340-5-1 (2007-08) and DIN EN 61340-5-2 (2007-08).

Hirschmann GRS103 Series Specifications

General

Brand	Hirschmann
Model	GRS103 Series
Category	Switch
Language	English