Installation GRS103
Release
01
03/2022
33
Figure 14: 2-pin terminal block
The signal contact allows you to control external devices or monitor device
functions.
In the configuration, you specify how the device uses the signal contact.
You will find detailed information on possible applications and the
configuration of the signal contact in the software user documentation. You
will find the software user documentation as PDF files on the Internet at
https://www.doc.hirschmann.com
5.4.2 USB-C interface: ACA22-USB-C
The USB-C interface allows you to connect the AutoConfiguration Adapter
ACA22 storage medium. It is used for saving/loading the configuration data
and diagnostic information, and for loading the software.
You have the option to configure your device using the USB-C interface. You
find detailed information in the software user documentation. You find the
software user documentation as PDF files on the Internet at http://
www.doc.hirschmann.com
The USB-C interface has the following properties:
Supports the USB host mode and USB device mode
Supports USB 2.0 (data rate max. 480 Mbit/s)
Connector: type C
Supplies current of max. 500 mA
Voltage not electrically insulated
Supported file system: FAT32
Note: A USB storage medium or USB cable is used exclusively for the
configuration of your device. Do not charge external devices using the
ACA22-USB-C interface.
Note: The ACA22 storage medium can remain permanently connected to the
device.
FAULT
To Next Page
Loading...
Need help?
General
