18
Installation GRS103
Release
01
03/2022
3.3 FCC note
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
GRS103
GRS103 modules
U.S. Contact Information
Belden – St. Louis
1 N. Brentwood Blvd. 15th Floor
St. Louis, Missouri 63105, United States
Phone: 314.854.8000
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
3.4 Relevant for installations in 19" switch
cabinets according to UL 60950-1/
UL 62368-1
Higher ambient air temperature during operation: If installed in a closed
switch cabinet or a multi-unit switch cabinet, the ambient air temperature
inside the switch cabinet during operation can be higher than the ambient
air temperature in the room. Install devices in environments that are
compatible with the maximum ambient air temperature of the device.
Reduced air flow: When you install the device in a switch cabinet, make
sure that a sufficient air flow is guaranteed in order to safely operate your
devices.
To Next Page
Loading...
Need help?
General
