Version 2.0, February 2012. Copyright 2012 Hitron Technologies
22
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
22
1.4.1 MANUAL IP ADDRESS SETUP
By default, your CGN2’s local IP address is 192.168.0.1. If your CGN2 is using the
default IP address, you should set your computer’s IP address to be between
192.168.0.2 and 192.168.0.254.
NOTE: If your CGN2 DHCP server is active, set your computer to get an IP address
automatically in step 5. The CGN2 assigns an IP address to your computer.
The DHCP server is active by default.
Take the following steps to manually set up your computer’s IP address to connect to
the CGN2:
NOTE: This example uses Windows XP; the procedure for your operating system
may be different.
1 Click Start, then click Control Panel.
2 In the window that displays, double-click Network Connections.
3 Right-click your network connection (usually Local Area Connection) and click
Properties.
4 In the General tab’s This connection uses the following items list, scroll
down and select Internet Protocol (TCP/IP). Click Properties.
5 You can get an IP address automatically, or specify one manually:
If your CGN2’s DHCP server is active, select Get an IP address
automatically.
If your CGN2’s DHCP server is active, select Use the following IP address.
In the IP address field, enter a value between 192.168.0.2 and
192.168.0.254 (default). In the Subnet mask field, enter 255.255.255.0
(default).
NOTE: If your CGN2 is not using the default IP address, enter an IP address and
subnet mask that places your computer in the same subnet as the CGN2.
6 Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click OK.
To Next Page
Loading...
Need help?
General
