Version 2.0, February 2012. Copyright 2012 Hitron Technologies
25
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
25
1.7 RESETTING THE CGN2
When you reset the CGN2 to its factory defaults, all user-configured settings are lost,
and the CGN2 is returned to its initial configuration state.
There are two ways to reset the CGN2:
Press the RESET button on the CGN2, and hold it in for ten seconds or longer.
Click WAN/LAN > Backup. In the screen that displays, click the Factory Reset
button.
The CGN2 turns off and on again, using its factory default settings.
NOTE: Depending on your CGN2’s previous configuration, you may need to re-
configure your computer’s IP settings; see IP Address Setup on page 21.
To Next Page
Loading...
