Hitron CGN2 - The Backup Screen; Figure 14: the WAN;LAN > Debug Screen; Table 14: the WAN;LAN > Debug Screen

Version 2.0, February 2012. Copyright 2012 Hitron Technologies
52
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
52
HITRON CGN2 USER’S GUIDE
Click WAN/LAN > Debug. The following screen displays.
Figure 14: The WAN/LAN > Debug Screen
The following table describes the labels in this screen.
3.5 THE BACKUP SCREEN
Use this screen to back up your CGN2’s settings to your computer, to load settings
from a backup you created earlier, to reboot your CGN2, or to return it to its factory
default settings.
Click WAN/LAN > Backup. The following screen displays.
Table 14: The WAN/LAN > Debug Screen
IP/URL Enter the IP address or URL that you want to test.
Method Select the type of test that you want to run on the IP/
URL that you specified.
Run Click this to perform the test.
Help Click this to see information about the fields in this
screen.