Hitron CGN2 - Password Screen

Version 2.0, February 2012. Copyright 2012 Hitron Technologies
41
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
41
HITRON CGN2 USER’S GUIDE
2.5 THE PASSWORD SCREEN
Use this screen to change the password with which you log in to the CGN2.
NOTE: If you forget your password, you will need to reset the CGN2 to its factory
defaults.
Click Status > Password. The following screen displays.
SCDMA Mode This displays the Synchronous Code Division Multiple
Access (SCDMA) mode of each channel on which the
upstream signal is transmitted.
Signal Power (dBmV) This displays the transmitted power of the signal of each
upstream data channel to which the CGN2 is connected,
in dBmV (decibels above/below 1 millivolt).
Channel ID This displays the ID number of each channel on which
the upstream signal is transmitted.
Cable Modem IP Information
IP Address This displays the CGN2’s WAN IP address. This IP
address is automatically assigned to the CGN2
Subnet Mask This displays the CGN2’s WAN subnet mask.
Gateway IP This displays the IP address of the device to which the
CGN2 is connected over the CABLE interface.
DHCP Lease Time This displays the time that elapses before your device’s
IP address lease expires, and a new IP address is
assigned to it by the DHCP server.
Table 9: The Status > CM Status Screen (continued)