Version 2.0, February 2012. Copyright 2012 Hitron Technologies
90
Version 2.0, February 2012. Copyright 2012 Hitron Technologies
90
Hidden Use this field to make your network visible or invisible to
other wireless devices.
Select the checkbox if you do not want the CGN2 to
broadcast the network name (SSID) to all wireless
devices in the coverage area. Anyone who wants to
connect to the network must know the SSID.
Deselect the checkbox if you want your network
name (SSID) to be public. Anyone with a wireless
device in the coverage area can discover the SSID,
and attempt to connect to the network.
In Service This field controls whether or not the SSID is in
operation.
NOTE: This field is user-configurable for the Primary
SSID only.
WMM Mode Select the checkbox if you want to apply Wifi MultiMedia
(WMM) Quality of Service (QoS) settings to this SSID.
Wireless Security
SSID Select the SSID for which you want to configure
security.
Security Mode Select the type of security that you want to use.
Select None to use no security. Anyone in the
coverage area can enter your network.
Select WEP to use the Wired Equivalent Privacy
security protocol.
Select WPA-Personal to use the WiFi Protected
Access (Personal) security protocol.
NOTE: Due to inherent security vulnerabilities, it is
suggested that you use WEP only if it is the only
security protocol your wireless clients support.
Under almost all circumstances, you should use
WPA-Personal.
WEP Settings
NOTE: These fields are only configurable when you select WEP from the Security
Mode list.
Table 27: The Wireless > Setup Screen (continued)
To Next Page
Loading...
Need help?
General
