Hobart Multi-Handler 200 User Manual

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1.................................
1-1. Symbol Usage 1.................................................................
1-2. Arc Welding Hazards 1............................................................
1-3. Additional Hazards For Installation, Operation, And Maintenance 3.......................
1-4. California Proposition 65 Warnings 4.................................................
1-5. Principal Safety Standards 4.......................................................
1-6. EMF Information 4................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5..........................
2-1. Symboles utilisés 5...............................................................
2-2. Dangers relatifs au soudage à l’arc 5................................................
2-3. Symboles de dangers supplémentaires en relation avec l’installation, le fonctionnement
et la maintenance 7...............................................................
2-4. Proposition californienne 65 Avertissements 8.........................................
2-5. Principales normes de sécurité 8....................................................
2-6. Informations relatives aux CEM 8...................................................
SECTION 3 − DEFINITIONS 9..................................................................
3-1. Additional Safety Symbols And Definitions 9..........................................
3-2. Miscellaneous Symbols And Definitions 10............................................
SECTION 4 − SPECIFICATIONS 11..............................................................
4-1. Serial Number And Rating Label Location 11...........................................
4-2. Software Licensing Agreement 11....................................................
4-3. Information About Default Weld Parameters And Settings 11..............................
4-4. Unit Specifications For MIG (GMAW) 11...............................................
4-5. Unit Specifications For TIG (GTAW) 11................................................
4-6. Unit Specifications For Stick (SMAW) 11..............................................
4-7. Environmental Specifications 12.....................................................
4-8. Dimensions And Weight 12..........................................................
4-9. Duty Cycle And Overheating For MIG (GMAW) 13......................................
4-10. Duty Cycle And Overheating For TIG (GTAW) 14.......................................
4-11. Duty Cycle And Overheating For Stick (SMAW) 15......................................
SECTION 5 − INSTALLATION 16................................................................
5-1. Selecting A Location 16.............................................................
5-2. Multi−Voltage Plug (MVP) Connection 17..............................................
5-3. Electrical Service Guide 18..........................................................
5-4. Input Power Extension Cord Data 18.................................................
5-5. Connecting 120 Volt Input Power 19..................................................
5-6. Connecting 1-Phase Input Power For 240 VAC 20......................................
5-7. Generator / Inverter Requirements 21.................................................
5-8. Stick Welding Connections 22.......................................................
5-9. TIG Welding Connections 23........................................................
5-10. Process/Polarity Table 24...........................................................
5-11. MIG Welding Connections 24........................................................
5-12. MIG Gun Connection Inside Unit 25..................................................
5-13. Connecting Shielding Gas Supply 26.................................................
5-14. Installing Wire Spool And Adjusting Hub Tension 27.....................................
5-15. Threading Welding Wire 28..........................................................
5-16. Removing MIG Gun To Replace With A Spool Gun 29...................................

Hobart Multi-Handler 200 Specifications

General

Brand	Hobart
Model	Multi-Handler 200
Category	Welding System
Language	English