OM-285922 Page 46
8-6. Troubleshooting
Trouble Remedy
No weld output; unit completely
inoperative.
Place line disconnect switch in On position.
Check and replace line fuse(s), if necessary, or reset supplementary protector.
Be sure power cord is plugged in and that receptacle is receiving input power.
No weld output; unit is on.
Check and secure loose weld cable(s) into receptacle(s).
Check and correct poor connection of work clamp to workpiece.
Erratic or improper welding arc or
output.
Use proper size and type of weld cable (see your Distributor).
Clean and tighten weld connections.
Verify electrode polarity; check and correct poor connections to workpiece.
Fan not operating. Unit not warmed up enough to require fan cooling.
Check for and remove anything blocking fan movement.
Have Factory Authorized Service Agent check fan motor and control circuitry.
Stick welding problems: Hard starts;
poor welding characteristics; unusual
spattering.
Use proper type and size of electrode.
Verify electrode polarity; check and correct poor connections.
Make sure a remote control is not connected.
TIG welding problems: Wandering arc;
hard starts; poor welding characteris-
tics; spattering problems.
Use proper type and size of tungsten.
Use properly prepared tungsten.
Verify electrode polarity.
TIG welding problems: Tungsten
electrode oxidizing and not remaining
bright after welding.
Shield weld zone from drafts.
Check for correct type shielding gas.
Check and tighten gas fittings.
Verify electrode polarity.
To Next Page
Loading...
Need help?
General
