Management over a Web Console
67
The PTZ panel takes effect for cameras that come with mechanical PTZ functions. It does not
support digital PTZ functions. To utilize its functions, select a view cell populated by a PTZ
camera, such as a speed dome.
Depending on the individual functions that come with PTZ cameras, some functions will not
be available for every camera. For example, the zoom controller will not apply for a PTZ camera
that comes without a mechanized zoom module
Event Panel
The event panel keeps up to 200 events and displays the latest 10 event entries with the
latest alarm on top of the list. Older events will be erased if the number exceeds 200.
It is polled every 10 seconds. A mouse hover on an alarm entry displays full information of the
event.
Note that multiple alarms can be triggered by one incident. See Setting-Event-Event on page
41 for how to configure the event settings.
If an event is configured with a recording action, there will be a play button to the left of
the alarm message.
Figure 7-10 Event Panel 2
Click and the event playback window will begin playback of a footage taken 10 seconds
before the occurrence of an alarm. The playback of an alarm-triggered recording will normally
last for one minute. If, however, you configured a shorter pre- and post-alarm recording time,
your alarm recording may be slightly shorter. The default for pre- and post-alarm buffer time
are 5 seconds and 20 seconds.
To Next Page
Loading...
Need help?
General
