Honeywell 30 Series User Guide

30 Series Network Video Recorder User Guide
6
Devices Connection
The following diagram shows a typical NVR connection:
Figure 2-1 Devices Connection
Starting and Shutting Down the NVR
Starting the NVR
1. Verify that the NVR is connected to an appropriate power source.
2. Turn on the power switch (See No. 11 in Figure 1-2) on the back panel to start the NVR.
Shutting Down/Reboot the NVR
To prevent damage to the hard drive, follow these steps to shut down the NVR:
1. In live view screen, click (Main Menu) on the main toolbar (see Figure 3-3 Main
Toolbar).

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)