Settings
41
Setting-Event-Event
The events reported from individual cameras’ alarm in /alarm out, and motion detection can
be accommodated in the NVR system's alarm settings. These events will then be reported or
trigger corresponding actions as follows:
• Record the video by the time the event is triggered.
• Reporting events via Email with snapshots attached.
• Sound the onboard buzzer.
• Triggering video snapshot and text message by the occurrences of events to an FTP site.
• Triggering a camera's alarm out.
• Triggering a PTZ camera(s) for its lens to move to a preset position.
• Sending notification to the HVMV for MS Window software.
• Sending a full screen live view on the connected monitor.
When an alarm is triggered, a message prompt will appear on the Liveview or any
configuration window.
Figure 6-18 Event
Creating an Event
Go to Event.
1. Click and the following window is displayed:
Figure 6-19 Create a New Event-Status
2. Manually enter a name. Up to 16 numeric or alphabetic characters is supported for the
name, including symbols such as [0-9] [a-z] [A-Z] [_] []. And then designate the interval
To Next Page
Loading...
