Honeywell 6808 - Point; Point Programming for SLC

6808 Manual — P/N LS10146-001SK-E:C 09/28/2017 103
Programming
9.5 Point
You may need to change characteristics of individual input points (detectors and switches) even after using JumpStart
®
Autoprogram-
ming. This section explains how to change options for: type of point, latching/non-latching, silenceable/non-silenceable, zone assign-
ment (input points), detector accessory base options, group assignment (output points), and point name.
9.5.1 Point Programming for SLC
To program points on SLC, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the up or down arrow key to select the desired module. Refer to Section 8.6 Quick Reference Table for available choices.
Then press ENTER.
5. Select S for sensor or M for module. (SK Only)
6. Enter the number of the point you wish to edit, then press ENTER.
7. Select the type of device by pressing the up or down arrow key. Refer to Table 9-3 under the column heading “Type Selection” for a
list of choices
Type Selection Function Latching Option Comments
UNUSED
SD DETECTOR
PHOTO
ION
HEAT
PHOTO DUCT
SD SUP DET
PHOTO
Latching
Non Latching
ION
HEAT
PHOTO DUCT
ION DUCT
SK DETECTOR
PHOTO
ION
HEAT
PHOTO DUCT
ACCLIMATE
HEAT HT
PHOTO-HEAT
BEAM
PHOTO
SK SUP
DETECTOR
PHOTO
Latching
Non Latching
Supervisory can be latching or non-latching.
ION
HEAT
PHOTO DUCT
ACCLIMATE
HEAT HT
PHOTO-HEAT
BEAM
CO SMOKE
DETECTOR
ALRM CO/
ALRM FIRE
SUP CO/
ALRM FIRE
ALRM CO/
SUP FIRE
SUP CO/
SUP FIRE
Latching
Detectors programmed as Supervisory can be latching or non-
latching.
Non Latching
W-DETECTOR
Photo Wireless photoelectric detector
Photo-Heat
Wireless heat detector
Heat
W-SUP-DET Same as W-Detector
Latching
Non Latching
Table 9.2 SLC Point Programming