6808 Manual — P/N LS10146-001SK-E:C 09/28/2017 39
Control Panel Installation
Flush Mounting
This section of the manual describes flush mounting. Follow these steps to flush mount the 6860
1. The back box dimensions are 9¼” W x 8 3/8” H. The minimum depth required is 2". The back box can be mounted prior to the
complete installation of the 6860 using any of the mounting holes shown in Figure 4.22.
Figure 4.22 Back Box Mounting Holes
2. Remove knockout holes as needed for wires. See Figure 4.23 for backbox knockout locations.
Figure 4.23 Back Box Knockout Locations
3. Wire the annunciator board to the main control panel. As described in Section 4.5.2.
Mounting Holes
Mounting Holes
Wire Knockouts
Wire Knockouts
Wire Knockouts
To Next Page
Loading...
