32 6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Control Panel Installation
4.5 5860 Remote LCD Annunciator Installation
The optional Model 5860 Remote LCD Annunciator, shown in Figure 4.9. Up to 12 annunciators can be added to the 6808 system in any
combination.
Figure 4.9 Model 5860 Remote LCD Annunciator, Front View
5860 installation involves the following steps:
1. Make sure power is off at the panel.
2. Mount the 5860 in the desired location (see Section 4.5.1).
3. Connect the 5860 to the panel (see Section 4.7).
4. Use the DIP switches on the back of the 5860 to assign an ID# to the 5860 (see Section 4.11.1).
5. The new 5860 module must be added to the system through programming. JumpStart
®
AutoProgramming will add the module
automatically (see Section 8.1). You can also add it manually (see Section 9.2.2). Select a name, if desired.
4.5.1 Mounting the 5860
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-mounted. Figure 4.10
shows the parts of the annunciator. Instructions for disassembling and mounting appear on the following pages.
Figure 4.10 Annunciator Parts
To Next Page
Loading...
