6808 Manual — P/N LS10146-001SK-E:C 09/28/2017 113
Programming
9.7 JumpStart
®
AutoProgramming
Panels support an incremental JumpStart.
For Example: After initial JumpStart & customization, if you add more devices, when you
JumpStart again the additional devices are added but you do not lose any of your previous custom programming
To run JumpStart:
1. Enter the installer code.
2. Select 7 for Program Menu.
3. Select 6 for JumpStart.
4. Press ENTER to accept the warning screen.
5. Follow the remaining on screen instructions.
6. Press ENTER to confirm. See Section 8.1.3.
9.8 Restore Defaults
This option allows you to restore the panel back to factory defaults. All programming will be lost.
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 7 for Restore Defaults.
4. Press the up or down arrow key to select YES or NO from the warning screen. Then press ENTER.
To Next Page
Loading...
