Honeywell Accenta Series User Manual

Accenta/Optima Engineer’s Manual
38
Programs (cont’d)
Immediate (Intruder) Zone
This is a zone which will, when enabled as used and then activated, go into alarm when the panel is set. To
assign a zone as immediate, remove the timed or timed inhibit function and make sure that it is enabled in the
Used Zones section.
4 = Entry Time
This is the time allowed to enter the premises via the entry route and unset the system. The programmable
range is 00-99 seconds. The actual time is multiplied by 10.
00 = 5 seconds
01 = 10 seconds
03 = 30 seconds
99 = 990 seconds (16.5 minutes)
The default is 30 seconds.
LCD Keypad:
While in Engineer program mode, to set the entry time,
• Press [PROG] to give a choice of programs or press
[up arrow] until P>Set Up Programs is displayed
then press [SET].
• Select program 1, 2 or 3.
• The first screen to appear is Program Edit Used
Zones.
• Press [4] to enter into Entry Time edit. The Entry
Time can now be changed.
• Enter a [2-digit number] from 00 to 99.
• Press [SET] to accept change or [RESET] to
cancel.
• Press [RESET] twice to leave menu.
[PROG]
[4]
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Entry Time? --Entry Time? --
Entry Time? --Entry Time? --
Entry Time? --
P>Select ProgramP>Select Program
P>Select ProgramP>Select Program
P>Select Program
1 2 or 31 2 or 3
1 2 or 31 2 or 3
1 2 or 3
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Used Zones Used Zones
Used Zones Used Zones
Used Zones
[Number]
[2-digit number] then [SET] or [RESET]
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Entry TimeEntry Time
Entry TimeEntry Time
Entry Time
[RESET]
P>Set UpP>Set Up
P>Set UpP>Set Up
P>Set Up
Programs Programs
Programs Programs
Programs
LED Keypad:
While in Engineer program mode, to set the entry time,
• Press [PROG] to give a choice of programs.LED’s 1,
2 and 3 are flashing.
• Select program 1, 2 or 3. If program 1 is selected,
LED 1 is ON.
• Select [4] to enter into Entry Time edit. The Entry
Time can now be changed. LED 1 is ON.
• Enter a [2-digit number] from 00 to 99. LED 1 is
ON.
• Press [SET] to accept change or [RESET] to cancel.
• Press [RESET] twice to leave menu.
[PROG]
[1]
[4]
[RESET]
12
3
4
5
6
7
8
12
3
4
5
6
7
8
12
3
4
5
6
7
8
[2-digit number] then [SET] or [RESET]
12
3
4
5
6
7
8
12
3
4
5
6
7
8

Honeywell Accenta Series Specifications

General

Zones	8
Power Supply	230V AC
Battery Backup	Yes
Tamper Protection	Yes
Communication Format	Contact ID, SIA
Communication	Wired
Compatible with	Honeywell detectors and accessories
Outputs	2