Honeywell Accenta Series User Manual

Accenta/Optima Engineer’s Manual
39
5 = Exit Time
This is the time allowed to leave the premises via the exit route before the system sets. The programmable
range is 00-99 seconds. The actual time is multiplied by 10.
If the Exit Time is interrupted within the last 10 seconds, then the Exit Time will restart at 10 seconds after
the interruption has cleared.
00 = 5 seconds
01 = 10 seconds
03 = 30 seconds
99 = 990 seconds (16.5 minutes)
The default is 30 seconds.
[PROG]
[4]
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Exit Time? --Exit Time? --
Exit Time? --Exit Time? --
Exit Time? --
P>Select ProgramP>Select Program
P>Select ProgramP>Select Program
P>Select Program
1 2 or 31 2 or 3
1 2 or 31 2 or 3
1 2 or 3
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Used Zones Used Zones
Used Zones Used Zones
Used Zones
[Number]
[2-digit number] then [SET] or [RESET]
P>Program EditP>Program Edit
P>Program EditP>Program Edit
P>Program Edit
Exit TimeExit Time
Exit TimeExit Time
Exit Time
[RESET]
P>Set UpP>Set Up
P>Set UpP>Set Up
P>Set Up
Programs Programs
Programs Programs
Programs
LCD Keypad:
While in Engineer program mode, to set the Exit Time,
• Press [PROG] to give a choice of programs or press
[up arrow] until P>Set Up Programs is displayed then
press [SET].
• Select program 1, 2 or 3.
• The first screen to appear is Program Edit Used Zones.
• Press [5] to enter into Exit Time edit. The Exit Time
can now be changed.
• Enter a [2-digit number] from 00 to 99.
• Press [SET] to accept change or [RESET] to cancel.
• Press [RESET] twice to leave menu.
LED Keypad:
While in Engineer program mode, to set the Exit Time,
• Press [PROG] to give a choice of programs.LED’s 1,
2 and 3 are flashing.
• Select program 1, 2 or 3. If program 2 is selected,
LED 2 is ON.
• Select [4] to enter into Exit Time edit. The Exit
Time can now be changed. LED 2 is ON.
• Enter a [2-digit number] from 00 to 99. LED 2 is
ON.
• Press [SET] to accept change or [RESET] to cancel.
• Press [RESET] twice to leave menu.
[PROG]
[2]
[4]
[RESET]
12
3
4
5
6
7
8
[2-digit number] then [SET] or [RESET]
12
3
4
5
6
7
8
12
3
4
5
6
7
8
12
3
4
5
6
7
8
Programs (cont’d)
12
3
4
5
6
7
8

Honeywell Accenta Series Specifications

General

Zones	8
Power Supply	230V AC
Battery Backup	Yes
Tamper Protection	Yes
Communication Format	Contact ID, SIA
Communication	Wired
Compatible with	Honeywell detectors and accessories
Outputs	2