Figure 57: Connecting the CIPer Model 50 to the PW M-Bus adapter
4.
Connect 24 V power to the M-Bus Adapter.
Risk of electric shock or equipment damage!
Due to the risk of short-circuiting (see Figure 24), it is strongly recommended that the CIPer Model 50 con-
troller be supplied with power from a dedicated transformer. However, if the CIPer Model 50 controller is to be
supplied by the same transformer powering other controllers or devices (e.g., the PW M-Bus Adapter), care
must be taken to ensure that correct polarity is observed.
To Next Page
Loading...
