Serial essernet
®
interface (SEI1)
68 FB 798819 / 05.18
Protocol Configuration
Active Interface (USIA)
Fig. 23: Protocol Configuration
Master (default)
Required setting for SEI1 type with Supervisor Gateway.
Activate Supervisor Gateway
This field switches the display characteristics for fault messages from the standard format to
management systems format. If the field is activated all fault messages will be transmitted using
the programmed primary loop number and the associated additional text exclusively to the
FACP for further display connected to the essernet
®
.
Infotext
This text will be displayed at the Fire Alarm Control Panels in the essernet
.
Printer text
Edit Text for printing on a system printer.
Primary loop
Edit a 4-digit primary loop number for FACP (refer to Fire Alarm Control Panel manual).
To Next Page
Loading...
