Honeywell HC30W45R3 - Configuring Streaming Protocols; Figure 5-4 Ipv6 Address; Figure 5-5 Manually Setup IP Address

Performance Series IP Camera Software Configuration Guide
46
Figure 5-4 IPv6 Address
Follow the steps below to link to an IPv6 address:
1. Open your web browser.
2. Enter the link-global or link-local IPv6 address in the address bar of your web browser.
3. The format should be: http://[2001:0c08:2500:0002:0202:d1ff:fe04:65f4]/
4. Press Enter on the keyboard or click Refresh button to refresh the webpage.
Note
If you have a Secondary HTTP port (the default value is 8080), you
can also link to the webpage using the following address format:
(see Configuring Streaming Protocols on page 46 for detailed
information.)
Manually setup the IP address: Select this option to manually set up IPv6 settings if your
network environment does not have DHCPv6 server and router advertisements-enabled
routers. If you check this item, the following blanks will be displayed for you to enter the
corresponding information:
Figure 5-5 Manually setup IP Address
Configuring Streaming Protocols
Go to SetupNetwork SetupStreaming Protocols.
Link-global IPv6 address/network mask
Link-local IPv6 address/network mask