Honeywell HC30W45R3 - Configuring DDNS Settings; Figure 5-9 DDNS

Configuring Network Settings
49
Multicast video port/Multicast RTCP video port: The ports can be changed to values
between 1025 and 65535. The multicast video port must be an even number and the
multicast RTCP video port number is the multicast video port number plus one, and thus is
always odd. When the multicast video port changes, the multicast RTCP video port will
change accordingly.
Multicast metadata port/Multicast RTCP metadata port: The ports can be changed to
values between 1025 and 65535. The multicast metadata port must be an even number and
the multicast RTCP metadata port number is the multicast metadata port number plus one,
and thus is always odd. When the multicast metadata port changes, the multicast RTCP
metadata port will change accordingly.
Multicast TTL [1~255]: The multicast TTL (Time To Live) is the value that tells the router the
range a packet can be forwarded. The default value is 15.
Configuring DDNS Settings
Go to SetupNetwork SetupDDNS.
This section describes how to configure the dynamic domain name service for the camera.
DDNS is a service that allows your camera, especially when assigned with a dynamic IP
address, to have a fixed host and domain name.
Figure 5-9 DDNS
Enable DDNS: Check to enable the DDNS setting.
Note
Before utilizing this function, apply for a dynamic domain account
first and then access the system through that domain. Refer to the
following link to apply for a dynamic domain account:
http://www.dyndns.com/
Provider: Select a DDNS provider from the dropdown list.
Host name: Enter the host name of your dynamic domain account.
User name: Enter the user name of your dynamic domain account.
Password: Enter the password of your dynamic domain account.