HF680 Series User Guide 41
following On barcode to use character activation, then use Activation Character
(following) to select the character you will send from the host to start scanning.
Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), find the hex value that
represents the character you want to use to trigger scanning. Scan the following
barcode, then use the Programming Chart to read the alphanumeric combination
that represents that ASCII character. Scan Save to finish.
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the aimer can
be programmed either to remain on and scanning, or to turn off. When End
Character Activation After Good Read is enabled, the aimer turns off and stops
scanning after a good read. If you scan Do Not End Character Activation After
Good Read, the aimer remains on after a good read. Default = End Character
Activation After Good Read.
Do Not End Character
Activation After Good Read
* End Character Activation
After Good Read
To Next Page
Loading...
Need help?
General
