Honeywell HF680 Series User Manual

HF680 Series User Guide 69
Codabar
<Default All Codabar Settings>
Codabar On/Off
Codabar Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the barcode. You
may either transmit, or not transmit Start/Stop characters. Default = Don’t
Transmit.
Codabar Check Character
Codabar check characters are created using different “modulos.” You can program
the scanner to read only Codabar barcodes with Modulo 16 check characters.
Default = No Check Character.
No Check Character indicates that the scanner reads and transmits barcode data
with or without a check character.
When Check Character is set to Validate and Transmit, the scanner will only read
Codabar barcodes printed with a check character, and will transmit this character
at the end of the scanned data.
* On
Off
Transmit
* Don’t Transmit

Honeywell HF680 Series Specifications

General

Image Sensor	CMOS
Symbol Contrast	20% minimum reflectance difference
Interface	USB, RS-232, Keyboard Wedge
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% (non-condensing)
Light Levels	0 to 100, 000 lux
Supported Barcodes	UPC/EAN, Code 39, Code 128, QR Code, Data Matrix