Honeywell HF680 Series - LED - Good Read

20 HF680 Series User Guide
Control Character Output
This selection sends a text string instead of a control character. For example, when
the control character for a carriage return is expected, the output would display
[CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart (Code Page
1252) on page 164. Only codes 00 through 1F are converted (the first column of
the chart). Default = Off.
Note: Control + ASCII Mode overrides this mode.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + ASCII Mode On: The scanner sends key combinations for ASCII control
characters for values 00-1F. Windows is the preferred mode. All keyboard country
codes are supported. DOS mode is a legacy mode, and it does not support all
keyboard country codes. New users should use the Windows mode. Refer to ASCII
Conversion Chart (Code Page 1252), page 164 for CTRL+ ASCII Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate any prefix or suffix
information.
Default = Control + ASCII Mode Off.
Convert All Characters
to Upper Case
Convert All Characters
to Lower Case
Control Character Output On
* Control Character Output Off