48 HF680 Series User Guide
• When setting up for specific symbologies (as opposed to all symbologies), the
specific symbology ID value counts as an added prefix or suffix character.
• The maximum size of a prefix or suffix configuration is 200 characters, which
includes header information.
To Add a Prefix or Suffix:
Step 1. Scan the Add Prefix or Add Suffix symbol (page 49).
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
the Symbology Charts) for the symbology to which you want to apply the
prefix or suffix. For example, for Code 128, Code ID is “j” and Hex ID is
“6A”.
Step 3. Scan the 2 hex digits from the Programming Chart or scan 9, 9 for all
symbologies.
To add the Code I.D., scan 5, C, 8, 0.
To add the AIM I.D., scan 5, C, 8, 1.
To add the serial number, scan 5, C, 8, 8.
To add a backslash (\), scan 5, C, 5, C.
Note: When adding a backslash (\), you must scan 5C twice – once to create the leading
backslash and then to create the backslash itself.
Step 4. Repeat Steps 2 and 3 for every prefix or suffix character.
Step 5. Scan Save to exit and save, or scan Discard to exit without saving.
Repeat the steps above to add a prefix or suffix for another symbology.
Example: Add a Tab Suffix to All Symbologies
Step 1. Scan Add Suffix.
Step 2. Scan 9, 9 from the Programming Chart to apply this suffix to all
symbologies.
Step 3. Scan 0, 9 from the Programming Chart. This corresponds with the hex
value for a horizontal tab, shown in the ASCII Conversion Chart (Code
Page 1252), beginning on page 164.
Step 4. Scan Save, or scan Discard to exit without saving.
Clear One or All Prefixes or Suffixes
You can clear a single prefix or suffix, or clear all prefixes/suffixes for a symbology.
If you have been entering prefixes and suffixes for single symbologies, you can use
Clear One Prefix (Suffix) to delete a specific character from a symbology. When
you Clear All Prefixes (Suffixes), all the prefixes or suffixes for a symbology are
deleted.
To Next Page
Loading...
Need help?
General
